產品資訊 - General Tile Adhesive->Epoxy Adhesive

登入

加入會員

求助

Guangzhou Mebong Architectural Decoration Co., Ltd.

	Recommended Results

General Tile Adhesive

產品分類 :

化學->其他->環氧樹脂黏合劑

產品規格

Model No:	PB-01

Country	CN
Brand	Mebong
Materials	cement
Size	25kg/bag
Weight	25kg
Color	white,gray
Packing	25kg/bag
Minimum Order	20 bags
Payment Term	TT

產品描述

Features:
1, A new type strong stone adhesive, applied to all kinds of ceramic tile and stone material.
2, No need to wet the brick wall, effectively improve the efficiency.
3, Strong bond ability, material-saving, much safer and firmer than the traditional cement adhesive, also can reduce the construct trash and the weight of the wall.
4, Good anti-infiltration and anti-aging function.
5, Can be directly used for leveling rough surface, or smooth cement floor.

Surface Treatment:
The substrate surface should be firm, dry and clean, no grease, no wax, or other loose materials.

Operation Process:
1, The ratio:PB-01: water=3.3: 1 (20kg/bag, about 6kg water). Stirring them into uniform paste, using an electric mixer can gain a best effect. Put it aside for a few minutes and then a little stirring to enhanced strength.
2, Using a tooth scraper to scrap the adhesive onto the surface evenly, control within 1㎡, then push the ceramic tile above it.
3, For the tile or stone material with deep ditch, not only scrape the surface, but also the backside of the tile or stone.
4, Leave 1.5mm joint space between two tiles, suggesting PB-MC Color Mould-resistant Grout.

Cautions:
1, Make sure the smoothness and vertical rate of the surface before operation.
2, Can not be walked on or filled the crack unless 24h after finished.
3, Operating under 5℃~40℃.
4, Can be used with brick-gap adhesive.
5, Never mix the dried slurry with water for second use.
6, Clean the surface by slightly wet sponge or cloth before it dried.

其他類似產品