Carnivel Auto Co. – 線上商品分類 : 交通運輸, 汽車, 汽車設備

登入

加入會員

求助

Carnivel Auto Co.

	Recommended Results

產品型錄

共2 筆產品

選取全部

全部取消

1. TOYOTA KEY PROG OBD

TOYOTA KEY PROG OBD

the programmer design simple, and operate easily through OBD directly and no need to press any button. Support all Toyota 4D chips, with the original key programming protocol, non-general initialization protocol.

Safe and highly effective: Only about 10 second to program a new key; the anti-thelf system will not be damaged in safe using way, it is the most quickly and safest programmer.

The operating step as follows: ( read the using step and the importance notice carefully)

1,Turn the ignition on with the right 4D chip key.

2,Connect the programmer to the OBD port of the car, there are some short beep sounds after power on. When the connection with the Computer of car is done successfully, there is a long beep sound in 3 seconds, and the “LED” is on, as well as the anti-light “SEC”, which means the car is in the “key programming state”.
3,Take away the programmer from OBD
Matches 2 pcs main key and 1 pc vice-key to the IMMO computer Notice: 2 new main key and 1 vice-key are needed to close the programming procedure
Close all the car door.
Insert the first new main key to the ignition for 5 seconds.
Insert the other main key to the ignition for 5 seconds.
Insert the vice-key to the ignition for 5 seconds.
The new ignition key will be confirmed by the new IMMO.
Only program 1 or 3 main keys to the IMMO computer( Manual close the mode after complete the programming
Close all the car doors.
Insert the new key for 5 seconds.
Insert another new key for 5 seconds.
Take out the key from ignition
Insert the first programmed main key, and turn on the ignition for 5 times quickly, then take it out
the new ignition key will be confirmed by IMMO
Notice:
must use the right Toyota 4D chip, otherwise you take the consequences.
Don’t try to open the cover of programmer and dash board
This machine is only provided for the legal auto repair.
Otherwise you will take the above consequences.

2. benz IR smart key prog

IR smart key prog/benz IR smart key programmer

The new Mercedes device working with smart key (old and new) using in car since 1997 up to 2005 - without keylessgo system. You can program new key (ore used) in car and program oun key if its not work more.You read and program eeprom of CPU from Steering blocking module
Product description
The new Mercedes device working with smart key (old and new) using in car since 1997 up to 2005 - without keylessgo system. You can program new key (ore used) in car and program oun key if its not work more.You read and program eeprom of CPU from Steering blocking module via diagnostic connector (38 pins). Desolder and read via programmer two CPU from Electronic Ignition Control Module.Load theese eeproms to program. Desolder NEC CPU from the key.Soldering it on the device , select the No of key and program it. Solder all CPU on their places and start the car.
You can program new keys without the car - only with EIS and steering blocking module.You can read theese CPU with help programmer (for ex. ETL) for Motorolla CPU 68HC705X16(32).