產品資訊 - Red metal floor hardener->handbag accessories

登入

加入會員

求助

Jiangmen Kasole Building Materials Co., LTD.

	Recommended Results

Red metal floor hardener

產品分類 :

服飾及紡織->配件->包包配件

產品規格

Model No:	KS-H160

Country	CN
Brand	Kasole
Packing	bags
Payment Term	L/C

產品描述

Red metal floor hardener are widely used in heavy machinery workshops, where dust, wear, and moisture are needed. The scope of application is for grounds where impact resistance and reduced dusting are required, such as: warehouses, docks, factories, parking lots, maintenance workshops, garages, warehouses, etc. It uses metal, non-metallic and other wear-resistant aggregates combined with a variety of additional hardener components, and solidified with the newly cast concrete layer to form a dense, wear-resistant, impact resistant smooth surface layer. 
Red metal floor hardener performance characteristics: 
1, impact resistance, heavy pressure, good mechanical properties; 
2, dust, mold, wear, hardness is good; 
3, resistance to heavy pressure, strong wear resistance, can not afford to dust, enhance the ground oil resistance, anti-infiltration; 
4, the appearance of bright, colorful and diverse; 
5, easy to clean, easy to maintain. 
Useful life 
Synchronize with concrete ground 
Basic requirements: 
The concrete strength of the grass-roots level shall be above C25, the water-cement ratio shall be controlled below 0.50, the difference between the concrete fall-out shall be controlled within 70-100mm, and the concrete mixture shall minimize segregation and control of bleeding; in order to ensure adequate flow of the concrete mixture Sex and construction are conducive to construction, it is recommended that concrete be added with proper additives. Grass-roots concrete should be poured and tamped with reference to the standard of fine concrete, pay attention to the size and reduce laitance production. The hardener surface is constructed simultaneously with the concrete structure layer. If the same leveling layer is to be applied at the same time, it is recommended that the leveling concrete should be fine stone concrete with a thickness of not less than 50mm. Consider configuring the telescopic reinforcement mesh with special attention to the corners of the concrete construction block. Ensure that the concrete in the area is vibrated and compacted and additional strengthening measures should be taken. 
Construction process 
Surface treatment: Use a machine equipped with a disc to evenly remove the laitance layer on the concrete surface; first spread the silicon carbide wear-resistant floor material: spread the prescribed amount of 2/3 hardened wear-resistant flooring material evenly. After the concrete surface of the initial coagulation stage, it is polished with a low-speed screeding machine; 
Scratch ruler leveling: Use a 6m scraper to evenly and horizontally erase and rough level the corundum wear-resistant flooring material; second time spread the material: uniformly spread the prescribed amount of 1/3 color diamond abrasive wear-resistant flooring material. (After the surface of the first ground diamond abrasive wear-resistant floor material), it is polished again with a trowel; surface polishing: According to the hardening of the concrete, the angle of the blade on the polishing machine is adjusted, and the surface polishing operation is performed to ensure the surface flatness. Smooth finish; base surface expansion: Emery wear-resistant floor should be maintained on the surface within 4 to 6 hours after the completion of the construction to prevent the rapid evaporation of surface moisture and ensure a steady increase in the strength of the diamond abrasion resistant floor. 
kasole-paint.com

其他類似產品